Aeration Systems EN 12255-15 Tested
Jul 11 2008 Read 1682 Times
in clean water in the aeration tanks of activated sludge. The new standard replaces older standards and unifies them under one common directive. DanielWeippert, General Manager for Tsurumi Europe, says the testing was a challenging but worthwhile exercise.
“We began our testing of equipment to this new standard at the earliest possible opportunity to ensure there would be no confusion or misunderstanding among our customer base,” he says. “Our customers want to know that when they buy from Tsurumi they are getting the very latest equipment both in terms of technology and in terms of
regulation. This was an expensive and time-consuming exercise on our part but we are proud to be among the first to have all our equipment correctly tested.”
To conform to EN 12255-15 equipment needs to have its oxygen transfer rates measured under defined standard conditions. These conditions specify that the oxygen should pass through an aeration tank filled with clean water. The water should be at a temperature of 20°C and at sea level altitude (atmospheric pressure of 1 atm). The testing of the new Tsurumi aeration equipment was performed over a period of more than two years. To be absolutely certain that it conformed to the high European standards, Tsurumi built a new and innovative testing ground at its factory in Kyoto, Japan. The new facility includes a purposebuilt
testing-basin with changeable dimensions up to a size of 10 m by 10 m and a maximum depth of up to 6 m. Not all manufacturers of aeration systems are publishing their oxygen input rates according to the new EN-norm and this is causing confusion says Daniel Weippert.
“Oxygen input rates measured according to older standards are often much higher than those taken in accordance with EN 12255-15,” he says. “So it may appear that a particular system has an input advantage over another system. This means the onus falls on customers to make sure when they are specifying aeration equipment that it is tested to EN12255-15.
Testing this way is the only true way to compare different systems and different manufacturers.”
Do you like or dislike what you have read? Why not post a comment to tell others / the manufacturer and our Editor what you think. To leave comments please complete the form below. Providing the content is approved, your comment will be on screen in less than 24 hours. Leaving comments on product information and articles can assist with future editorial and article content. Post questions, thoughts or simply whether you like the content.
May 16 2019 Telford, UK
May 16 2019 Guangzhou, China
May 20 2019 Perth, Australia
May 21 2019 Shanghai, China
May 22 2019 Rotterdam, Netherlands